Glow-worm Flue - Manual (Page 14)

0020095198_02 - 06/11 - Glow-worm
INSTALLATION
- 14 -
Make sure the nib fits into the locating slot in the
appliance casing to ensure correct orientation.
With the flue adapter fitted, measure the flue length required.
The use of a sliding sleeve will allow the appliance to
be easily removed and replaced without dismantling
the flue.
Ensure that at least one fixing bracket supports each
extension pipe used.
DO NOT connect the final extension until the flue
terminal has been positioned.
• Secure the extension pipe to the flue adapter with the
securing collar supplied, by positioning the collar centrally
over the joint then tightening the two screws on the securing
collar.
• Fit additional extension pipes as required using the collar
and screws supplied with each extension pipe.
• To fit, position the collar centrally over the joint and tighten
the two screws on the securing collar.
• Using the holes provided in the securing collar drill and insert
the two self tapping screws supplied, see diagram 6. The
rubber ‘O’ rings of each section should be lubricated prior to
assembly.
• Project the rise of the flue to roof level. The flue terminal will
require a 150mm hole.
5.3 flue Terminal Installation
Pitched Roof
Fit the required pitched roof weather collar over the 150mm
hole in the roof. Make good the tiling or slating around the collar
incorporating the flashing of the weather collar. Position the
angle cap over the weather collar in the correct orientation to
attain the correct angle for your roof.
flat Roof
Fit the aluminium weather collar over the 150mm hole in the
roof ensuring a weather tight seal.
From above carefully place the flue terminal through the
weather collar.
5.4 Ridge Tile Terminal
A ridge tile terminal is available - part no. A2043800, see Flue
Systems at the front of this literature.
The installation of a ridge tile will be required.
A suitable ridge tile is manufactured by: -
Aspect East Anglia Limited
The Old Mill
East Harling
NORWICH
NR16 2QW
Website: www.aspectroofing.co.uk
Contact: Chris Haythorpe
General Manager - Tile Division
Tel: 01953 717777 Fax: 01953 717164