Go Power! GP-1750HD - Manual (Page 13)

Go Power! Modified Sine Wave Inverter
Owner’s Manual
13
Inverter switched off.
No power to
inverter. Turn inverter on. Check
wiring to inverter.
Internal fuse open. Have qualified service
technician check and replace.
No output voltage, no voltage
indication.
Reverse DC polarity. Have qualified service
technician check and replace
fuse, OBSERVE CORRECT
POLARITY.
No output voltage, voltage
indicator in upper red zone. High input voltage. Make sure that inverter is
connected to 12 V battery.
Check regulation of charging
system.
Low battery alarm on all the
time, voltage indicator below
11 V Poor DC wiring,
poor battery
condition. Use proper cable and make
solid connections. Use new
battery.
No output voltage, Over
Temp indicator on, load in
excess of:
2500 W: 210 A
1750 W: 145 A Thermal shutdown. Allow inverter to cool off.
Reduce load if continuous
operation required.
No output voltage, Over
Temp indicator On, load less
than:
2500 W: 210 A
1750 W: 145 A Thermal shutdown. Improve ventilation, make
sure ventilation openings in
inverter are not obstructed,
reduce ambient temperature.
Short circuit or
wiring error. Check AC wiring for short
circuit or improper polarity
(hot and neutral reversed). No output voltage, Over Load
indicator on
Very high power
load Remove load.
8. Maintenance
Very little maintenance is required to keep your inverter operating properly. You
should clean the exterior of the unit periodically with a dry cloth to prevent
accumulation of dust and dirt. At the same time, tighten the screws on the DC input
terminals.
9. Warranty
We warrant this product against defects in materials and workmanship for a period of
12 months from the date of purchase and will repair or replace any defective Go
Power! Inverter when directly returned, postage prepaid, to the manufacturer. This
warranty will be considered void if the unit has suffered any obvious physical damage
or alteration either internally or externally, and does not cover damage arising from
improper use such as plugging the unit into an unsuitable power sources, attempting
to operate products with excessive power consumption requirements, reverse
polarity, or use in unsuitable climates.
This is the only warranty and the company makes no other warranties, express or
implied, including warranties of merchantability and fitness for a particular purpose.
Repair or replacement are your sole remedies and shall not be liable for damages,
whether direct, incidental, special or consequential, even though caused by
negligence or other fault.