GoDEX G500 series - Manual (Page 36)

32
5 Accessories
G500 Series
Installing The Cutter
 The Overview Of The Cutter
Before installing the cutter module, remove the cutter cover as shown in the illustration.
 Preparation Steps
Please complete the preparation steps before installing the label dispenser.
5-2
Accessories
032
CONNECT CABLE OF CUTTER MODULE
Remove the cutter cover

Remember to switch off the printer before installing the cutter.

Do not use to cut adhesive labels! Glue residue will be left on the cutter blade and impair its
functioning. The cutter has a blade life of 400,000 cuts when using paper liner which is
250μm thick and 3 inches wide.

You can cut paper with a max. width of 116 mm.
NOTICE

With the cutter installed, set the stop position in QLabel to 28, or the E value to 28. SUGGESTION
SCREWS
CUTTER MODULE