HITEC X2 Ultima: DC/DC, 200 Watt, Dual Port Multi-Charger - Manual (Page 17)

CHARGING LITHIUM BATTERY IN THE CHARGE MODE
INC INC DEC D E C
- -
+ +
Start
Enter
Batt type
Stop
Start
Enter
Charged
capacity
Number
of
cells
Charging
time
Charging
current
Battery
voltage
The left side of the first line shows the type of battery you
choose. The value on the left of the second line of the
charger is the current user set up. After setting the current
and voltage, press the Start/Enter key for more than 3
seconds to start the process (charge current: 0.1-10.0A,
voltage: 3.7-22.2V).
This displays the number of cells you set up and the
processor detects. “R” shows the number of cells detected
by the charger and “S” is the number of cells set by you at
the previous screen. If both numbers are identical, you can
start charging by pressing the Start/Enter button. If not,
press the Batt Type/Stop button to go back to the previous
screen. Carefully check the number of cells of the battery
pack before proceeding.
This screen shows the real-time status during the charge
process. Press the Batt Type/Stop key once to stop the
charge process.
This charging mode is for charging Li-Po/Li-Ion/LiFe batteries without a balance lead.
Charging Lithium battery in the charge mode
16
'> 3 seconds'