HITEC X2 Ultima: DC/DC, 200 Watt, Dual Port Multi-Charger - Manual (Page 24)

For your convenience, the X2 Ultima has a data storage and load program. It can
store the data of ten batteries, representing the respective specifications of each
battery. You can call back the data when charging or discharging without re-setting
the program. Press the Start/Enter key to make it blink, and use the Inc or Dec to
set up the parameter.
Storage data program
STORAGE DATA PROGRAM
Voltage
Data
number
CapacityType of
battery
Start
Enter
Setting of the parameter in the screen will not affect the
charge and discharge process. It simply presents the
specification of the battery. The example screen shows a
NiMH battery pack, including 12 cells, with a capacity
of 3000mAh.
DEC INC
DEC
DEC D E C
-
-
-
INC
INC INC
+
+
+
Start
Enter
Batt type
stop
Set up the discharge current and the final voltage.
Set up the charge current in the "manual" mode, or the current
limit in the "auto" mode. Press the Inc and Dec key
simultaneously to make the current field blink to switch
the charge mode.
DEC INC
Save the data.
DEC DEC
- -
INC INC
+ +
Start
Enter
Set up the charge/discharge sequence and cycle number.
23
'> 3 seconds'
'> 3 seconds'