HITEC X2 Ultima: DC/DC, 200 Watt, Dual Port Multi-Charger - Manual (Page 20)

CHARGING LITHIUM BATTERY IN THE STORAGE MODE
Number
of
cells
DEC
- +
At this screen, you can set up the current and voltage of
the battery pack. Charging and discharging will make the
batteries come to the voltage level of the “storage” mode.
Batt type
Stop
Elapsed
time
INC
Charge
or discharge
current
Supplied
capacity
DEC
Start
Enter
-
INC
+
Current
voltage
battery
Charging Lithium battery in the storage mode
This is for charging or discharging a Lithium battery not to be used immediately. The
program will determine whether to charge or discharge the battery to the certain
voltage depending on the voltage of the battery at its initial stage. Different voltages
exist for each type of battery: 3.75V for Li-Ion, 3.85V for LiPo and 3.3V for LiFe per
cell. If the voltage of the battery at its initial stage is over the voltage level for
storage, the program will start to discharge.
Number
of
cells
DEC
-
Batt type
Stop
elapsed
time
INC
+
Battery
voltage
DEC
Start
Enter
-
INC
+
Discharged
capacity
The value of the discharge current on the left can not
exceed 1C, and the value on the right can not be under the
voltage recommended by the manufacturer to avoid deep
discharging. Press the Start/Enter key for more than 3
seconds to start discharging.
discharge
current
Discharging of Lithium battery
This screen shows the real-time status charging. Press
the Batt Type/Stop key once to stop the charge process.
This shows the real-time status of discharging, you can
press the Batt Type/Stop key to stop discharging.
19
'> 3 seconds'
'> 3 seconds'