JUGS Sports Lite-Flite Machine - Manual (Page 14)

13
Unpacking
! WARNING: To prevent accidental starting, or electrical shock that could
cause possible serious injury, assemble all parts to your
machine before connecting it to the power supply . The pitching
machine should never be connected to a power supply when
you are assembling parts, making adjustments, cleaning,
servicing, or when you are not using it .
• Carefully lift the machine from the carrying bag and place it on a level
surface .
• Make sure you have all the parts (see nomenclature, pages 11 & 12) . If
any parts are missing, do not operate the machine until the missing parts
are replaced . Failure to do so could result in possible serious personal
injury .
• Do not discard the packing materials until you have carefully inspected the
machine, identified all the parts, and satisfactorily operated the machine .
NOTE: If any parts are damaged or missing, do not attempt to plug in the
power cord and turn on the switch until the damaged or missing parts are
obtained and are correctly installed .
Set Up
1 . With machine upside down resting on grip handle, place the triangular leg
clamp in the leg clamp casting .
2 . Insert the threaded end of the T-handle through the center hole in the leg
clamp casting, and start the threads .
3 . Install one leg in each round hole in the center piece of the leg clamp
casting . Tighten the T-Handle sufficiently to hold the legs very snugly in
place as shown in figures 4 and 5 .