JUGS Sports Lite-Flite Machine - Manual (Page 18)

17
Operation
(continued)
10 . When you increase the speed of fastballs, you must lower the
elevation of the aim; when you decrease speed, you must increase the aim
elevation .
11 . Space all pitches approximately six seconds apart . Try to get the batter
to regard each pitch as a “separate” pitch—and not to be an “automatic”
swinger .
12 . Always “show” the ball to the batter . When you are certain the batter has
acknowledged that he or she is ready, set the ball in the feed chute and
release it . Do not drop the ball into the chute .
13 . Do not permit more than one or two persons around the pitching machine
during its operation .
14 . Always turn the speed dial to the minimum position when throwing is
completed or temporarily stopped . Then turn the ON/OFF switch to the
OFF position .
! WARNING: A pitching screen must be used to protect the operator and
the machine from batted balls .
NOTE: We suggest that each operator spend a couple of hours
experimenting with the JUGS pitching machine . Try many different pitch
settings . Do not be afraid that any setting you make will harm the pitching
machine; however, you should use a wide backstop when experimenting
with faster speeds .
IMPORTANT: If the machine becomes wet during practice, turn it off
immediately, and transport it to a clean, dry location . Wipe off surface water
with a soft, clean cloth and permit the machine to air dry completely before
its next use .