Konig Electronic High definition DVB-S2 plug-in receiver - Manual (Page 16)

2.5 Multi Satellite Search
From the Multi Satellite Search window you can search several satellites at
the same time.
1. Satellite: All selected satellites in the satellite list window are displayed in
the lower section. You can press the keys to switch between them.
2. FTA Only: Press the keys to select between Yes and No.
3. Scan Channel: Press the keys to select between TV+Radio, TV
Channel, Radio.
4. Network Search: Select between Yes and No. This item turns grey when
Auto Scan is selected in the following Scan mode item.
5. Scan Mode: Press the keys to select between Auto Scan and
Preset Scan. Auto Scan is a Blind scan, while Preset Scan searches the
preset frequencies.
6. Search: Press the OK key to start searching.
2.6 TP List
1. Press the PR+, PR-.keys to select the proper satellite.
2. Press the red key to pop up the Edit TP window.
Frequency, Symbol rate: Press the keys to add or reduce step by
step. Or press the numeric keys (0-9) to input the desired value.
The range of the frequency is 3000-13500, while the range of the symbol
rate is 1000~45000. If the input value is beyond this range, the value will
return to the original value.
Polarity: Press the
keys to switch between Vertical and Horizontal.
3. Press the green key to pop up the Add TP window. Same operation as the
above Edit TP window.
4. Press the yellow key to pop up the dialogue box “Are you sure you want
to delete?”. Press the OK key on the Yes option to delete the selected TP,
or press the EXIT key to cancel the operation.
16