Konig Electronic High definition DVB-S2 plug-in receiver - Manual (Page 25)

6. Press the OK key on the star button to begin updating. Press the green
key to delete the number or characters and press the red key to switch
the input mode.
8.4 Weather forecast
Press the green key to enter city
Press the yellow key to delete city
Press the red key to update
8.5 RSS reader
RSS channel list is on the left side of the window.
RSS news list is on the right side of the window.
Press the PR+, PR+ key to select the channel you want
Press the red key to update
Press the green key to add a channel
Press the yellow key to delete a channel
Press the blue key to edit a channel
Problem Possible causes What to do
The display on the front panel
does not light up.
Main cable is not connected.
Check that the main cable is
plugged into the power socket.
No sound or picture, but the front
panel shows a red light.
The receiver is in standby mode. Press the standby button.
The satellite dish is not pointing at
the satellite. Adjust the dish. Check the signal
level in the Antenna Setup menu.
No sound or picture.
No signal or weak signal.
Check the cable connections, LNB
and other equipment connected
between the LNB and the receiver,
or adjust the dish.
The satellite dish is not pointing at
the satellite.
Adjust the dish.
Signal is too strong.
Connect a signal attenuator to the
LNB input.
Satellite dish is too small. Change to a larger dish.
LNB noise factor is too high.
Change to an LNB with a lower
noise factor.
Bad picture / blocking error.
The LNB is faulty. Change the LNB.
The picture is not showing on the
screen, when switched on. The system is connected by RF
leads.
Check the UHF channel selected
in your system and tune the UHF
channel properly.
There is interference with your
digital satellite channels, an
existing terrestrial channel or video
signal.
The system is connected by RF
leads and the output channel of
the receiver interferes with an
existing terrestrial channel or video
signal
Change the receiver output
channel to a more suitable
channel, or connect the system by
SCART Leads.
Batteries are exhausted. Change the batteries.
The RCU is not working.
RCU is incorrectly aimed.
Aim RCU at the receiver, or check
that nothing blocks the front panel.
Note: If you have tried all of the actions suggested above, without resolving the problem, please contact your
dealer or service provider.
25