Konig Electronic High definition DVB-S2 plug-in receiver - Manual (Page 19)

4.1 Information
Press the OK key on the Information window.
4.2 Factory Setting
Press the OK key to enter the Factory Setting window.
Select the Yes option and press the OK key to return to the factory setting. All
searched channels and set information will be erased.
Select the No option and press the OK key to cancel this operation, or press
the MENU or EXIT key to cancel and exit.
4.3 Upgrade By RS232
1. Press
the keys to select between all code, Main code, card, Radio
back, key date default db, user db. The default option is all code.
2. Press the OK key on the Start button to start checking the serial port.
4.4 S/W Upgrade by OTA
1. Satellite, Transponder: Select the proper satellite or transponder.
2. Frequency, Symbol Rate, Download PID: Use the numeric keys to input
the proper value.
3. Polarity: Select between H and V.
4. Start: Press the OK key to start upgrading.
If there is no correct information, system will display “Collecting information”.
You can press the OK key on the Stop button and then press the OK key on
the Exit button to return to the previous window.
The system will start upgrading after collecting the information successfully.
Press the OK key on the Download button and press the OK key on the Burn
flash button to start burning. After booting, press the OK key on the Reboot
button to reboot.
4.5 Conditional Access (Not active for this model)
Insert the smart card with the chip facing down.
Push the smart card into the CA slot. Only a few millimeters of the card should
be visible outside the slot.
Select the Conditional Access item and press the OK key.
You will then enter its sub-menu which consists of four items about CA Info,
Change PIN, Change Signature PIN, Maturity Level.
19