Lab.gruppen PLM 20000Q - Manual (Page 49)

Front Panel Interface
43
PLM Series Operation Manual rev 1.2.3
Output limiter (gain reduction) meters take
into account the sum of PLM ISVPL and Lake
LimiterMax.
The icons in the center of the LCD indicate the amplifier channel to which each module output is routed.
When two amplifier channels are Bridged, both channels will be displayed.
The type of icon used in the center of the screen confirms whether the PLM outputs are configured in
Standard mode or Bridge Mode, as shown in Figure 7-5. For further information on Bridge Mode, please
refer to section 8.1.1.
Figure 7-5: Standard and Bridge Mode Front Panel Icons
Bridge Mode is visible via this icon notation on the PLM Front Panel in Home View, however, the
Lake Controller must be used to configure Bridge Mode; please refer to the Lake Controller Operation
Manual for further information.
Home View looks similar for most configurations, with slight variations dependant on the PLM model and
processor configuration.
7.10.2 Module View
Module View provides further signal level information in the form of additional power output meters as
shown in Figure 7-6.
Figure 7-6: Meter Mode > Module View
Current View title & Frame label, Frame faults and warnings
Module A label and input gain meter