Labconco Protector Demonstration Hoods 3945021 User Manual
Page 10
Product Service 1-800-522-7658
6
C
C
h
h
a
a
p
p
t
t
e
e
r
r
3
3
:
:
G
G
e
e
t
t
t
t
i
i
n
n
g
g
S
S
t
t
a
a
r
r
t
t
e
e
d
d
Now that the site for your Protector Demonstration Hood is properly
prepared, you are ready to unpack, inspect, install, and validate your hood
system. Read this chapter to learn how to:
• Unpack and move the hood.
• Set up the hood with the proper supporting structure and work
surface.
• Connect to an exhaust system.
• Connect the electrical supply.
• Seal the hood to the work surface.
• Arrange validation for the enclosure.
Depending upon which model you are installing, you may need common
plumbing and electrical installation tools in addition to wrenches, ratchets,
sockets, a nut driver set, a flat-blade screwdriver, a Phillips screwdriver, and
a carpenter level to complete the instructions in the chapter.
The hoods weigh either 100 or 120 lbs. each (45 to 54 kg). The shipping
container allows for lifting with a mechanical lift truck or floor jack. If
you must lift the hood manually, follow safe-lifting guidelines.
Do not
lift by the front air foil
.