Labconco Protector Demonstration Hoods 3945021 - Manual (Page 23)

Chapter 4: High Performance Features and Safety Precautions
Product Service 1-800-522-7658 19
10. Electrical Pass through Iris allows electrical cords and data cords to
pass through the back of hood without leaving a large hole for
contaminants to escape. The hood ships with solid plugs and the iris
plugs are included with the instruction manual for your convenience.
11. Shipped fully assembled to eliminate the need for costly onsite
assembly. Accessories such as the exhaust transition connections,
work surfaces, airflow monitors and fluorescent light kits are easily
installed.
12. Accessory Exhaust Connections. The Protector Demonstration
Hoods feature two exhaust locations: One is located on the top of the
rear plenum and the other is located on the bottom of the rear plenum.
The bottom exhaust incorporates a tissue screen to prevent debris
from clogging the exhaust blower. Exhaust transition connectors are
available for either a 6" OD outside exhaust or a 5" ID hose. All
exhaust transition connectors are illustrated in Chapters 2 and 3 and
accessories listed in Chapter 7. The lower 5" ID hose exhaust
connection is used with the mobile cart for connection to the
FilterMate Portable Exhauster which rests on the lower shelf.
13. Accessory Guardian™ Digital 1000 Airflow Monitor or Guardian
500 Monitor continuously monitors airflow. An audio/visual alarm
alerts the user to low airflow conditions. The Guardian™ 1000
Digital Airflow Monitor also displays a face velocity value, provides
an RS232 output, a night setback mode and several auxiliary relay
ports. See Chapter 7 for ordering information. See Chapter 6 for
details, installation and calibration.
14. Accessory Fluorescent Light Kits provide excellent illumination
with an auxiliary outlet plug for supplying power to auxiliary
equipment such as a balance or printer. See Chapter 7 for ordering
information.
15. Accessory Roof-Mounted Blower sized to provide adequate airflow
to Protector Demonstration Hoods when used with an exhaust
damper. See Chapters 2, 3 and 7.
16. Accessory FilterMate Portable Exhauster provides up to 280 cfm
for HEPA or Carbon filtration or up to 220 cfm for combination
HEPA/Carbon filtration when connected to the hood. See Chapters 2,
3 and 7.
17. Mobile Demonstration Hood includes FilterMate Portable
Exhauster, Demonstration Hood, work surface and mobile cart to
allow easy transport throughout the facility. See Figure 3-6. Mobile
cart can be ordered separately as shown in Chapter 7.