Labconco Protector Demonstration Hoods 3945021 - Manual (Page 12)

Chapter 3: Getting Started
Product Service 1-800-522-7658 8
Work Surface Specifications
The work surface should be smooth, rigid, and durable, such as a chemically
resistant epoxy resin. The surface should be non-porous and resistant to the
acids, solvents and chemicals used in conjunction with the Protector
Demonstration Hood. The work surface should also contain a dished
recessed area for containing primary spills.
Work Surface and Hood Installation
1. Level the base cabinets and the work surface. Work surface should be
placed flush with the front of the base cabinet as shown in Figure 3-1.
2. Position the work surface in its intended location and with the front of
the work surface (wide flange) towards you.
3. Secure the work surface to the base cabinet with a structural adhesive
or silicone sealant.
4. Insert the supplied mounting screws in the four holes. Allow a
minimum of 1/8" clearance under the head of the screw for
positioning the enclosure.
5. Place the hood on the work surface and slide the rear flange and front
air foil flanges under the mounting screw heads.
6. Tighten the four screws to complete the installation.
Figure 3-1
Side View of Typical Installation
Airflow monitor moved
forward per Chapter 6.