Centrivap micro ir components, Setting up your centrivap micro ir, Emergency access into the chamber – Labconco CentriVap micro IR Vacuum Concentrators 77010 Series User Manual
Page 12
Chapter 3: Getting Started
Product Service 1-800-522-7658
8
CentriVap micro IR Components
As previously mentioned, the CentriVap micro IR System is available in 115V or
230V. Locate the model of CentriVap you received in the following table. Verify
that the components listed are present and undamaged.
Catalog # Product Description
7701020
CentriVap micro IR Concentrator – 115V – USA
1334500 Power Cord with NEMA 5-15P Plug
7548500 Rotor 1.5ml x 24
7539801 User’s Manual
7548900 Wrench, Rotor
7549000 CentriZap micro IR LED Strobe Light
7701030
CentriVap micro IR Concentrator – 230V – EU
1336100 Power Cord with CEE 7/7 Plug
7548500 Rotor 1.5ml x 24
7539801 User’s Manual
7548900 Wrench, Rotor
7549000 CentriZap micro IR LED Strobe Light
7701035
CentriVap micro IR Concentrator – 230V – UK
1332600 Power Cord with BS 1363 Plug
7548500 Rotor 1.5ml x 24
7539801 User’s Manual
7548900 Wrench, Rotor
7549000 CentriZap micro IR LED Strobe Light
7701037
CentriVap micro IR Concentrator – 230V – CHINA
1332700 Power Cord with CHI-10P Plug
7548500 Rotor 1.5ml x 24
7539801 User’s Manual
7548900 Wrench, Rotor
7549000 CentriZap micro IR LED Strobe Light
If you do not receive one or more of the components listed for your CentriVap
micro IR, or if any of the components are damaged, contact Labconco
Corporation immediately for further instructions.
Setting Up Your CentriVap micro IR
After you verify receipt of the proper components, move your CentriVap micro
IR to the level and sturdy location where you want to install it. There is no need
to secure the CentriVap micro IR Concentrator to the work surface. Then, follow
the steps listed below.
Emergency Access Into the Chamber
The CentriVap micro IR is designed to prevent access to the chamber in the event of a
power disruption. If it is necessary to open the lid when there is no electrical power
connected to the unit, you can unlock the latch by pulling on cable release located in the
top left-hand rear corner of the back panel. Pulling the cable out will unlock the lid
latch mechanism. While holding the latch open, raise the lid with the other hand.