Labconco CentriVap micro IR Vacuum Concentrators 77010 Series - Manual (Page 18)

Chapter 4: Using Your CentriVap micro IR
Product Service 1-800-522-7658 14
65.0
1. Display – Shows set point parameters and actual measured conditions.
2. Start/Stop Button – Used to start or stop a run and reset the timer.
3. Time Button – Used to display time remaining.
4. Set Button – Use to program temperature and time.
5. Increase Button – Use to increase temperature and time in set up mode.
6. Decrease Button – Use to decrease temperature and time in set up mode.
7. Standby Light – Indicates that the selected heater is on and cycling.
8. Power Light – Indicates the unit is in Standby or Run mode.
9. Heat Mode Selector – Use to select IR, IR/Heat, or Heat only modes.
10. Run Mode Selector – Use to select Off, Standby (Preheat) or Run modes.
Operating the CentriVap micro IR Controls
Change “Temperature” and “Run Time” Set Point:
To change the temperature set point, press the “SET” button. The current temperature
set point will flash on the display. Press the increase or decrease button until the desired
temperature set point is displayed. Press “SET” button and the current hour set point
will flash. Press the increase or decrease button until the desired run hours (00: to 99:)
is displayed. Press “SET” button and the current minutes set point will flash. Press the
increase or decrease button until the desired run minutes (:00 to :59) is displayed. Press
the “SET” button and save will flash on the display. The new program is now entered,
the display will show the current chamber temperature. Setting the run time to 00:00
will turn off the program timer. With the timer off the unit will operate at the set point
temperature until manually turned off.
The temperature set point range is 35°C to 65°C.
10
2
4
1
5 6 7 9
3
8