Electrical connection, Drying chamber or drying manifold installation, Chemical resistance of freeze dryer components – Labconco FreeZone and FreeZone Plus 6, 12 and 18 Liter Freeze Dry Systems 79600 Series User Manual
Page 19
15
Chapter 3: Getting Started
Product Service Domestic 1-800-522-7658, International 816-333-8811
The lower front panel is installed by first sliding the top edge under
the lip on the plastic control panel. Pivot the bottom inward and
push until the latch is secure.
Electrical Connection
Plug the power cord into the receptacle on the back of the Freeze
Dryer and plug the other end into a suitable power receptacle.
Drying Chamber or Drying Manifold
Installation
The drying chamber or drying manifold, purchased separately, may
be positioned directly above the 3-inch port on the top of the
Freeze Dryer. Follow the instructions supplied with the selected
accessory.
Chemical Resistance of Freeze Dryer
Components
The FreeZone Freeze Dry System is designed to be chemically
resistant to most compounds that are commonly used in freeze
drying processes. However, by necessity, the Freeze Dryer is
comprised of a number of different materials, some of which may
be attacked and degraded by certain chemicals. The degree of
degradation is dependent on the concentration and exposure
duration. Some of the major components of the FreeZone Freeze
Dry System that are susceptible to degradation are as follows: