MOCET IG7600 - Manual (Page 20)

IG7600 Administration Manual
3.18 Direct Inward System Access (DISA)
The feature allows you to remotely access IG7600 lines to make the outside calls. The
current PSTN/IP lines are all DISA lines. While ringing to Auto Attendant, the outside
callers have direct access to extensions, or make an outside call,
The out-calling is to dial a pound (“#”) key at the beginning when Auto Attendant plays the
greeting message. The call is secured by means of verified passwords against the
assigned extension number. The use is accomplished only when a valid extension
number has been entered and when the password entered matches that stored for the
extension number entered.
The DISA function is disabled by default.
3.19 Emergency Call
IG7600 allows you configure five Emergency Call numbers and lines with which
Emergency Calls are sent out. Any user can make an Emergency Call regardless of its
Call Routing table, Call Restriction, and Phone Lock, when they dial a pre-configured
Emergency Call number. The numbers of Emergency Call must not collide with the
numbers in Numbering Plan.
It allows programming 5 emergency numbers. “911” is in it by default.
3.20 Extension Password
All extensions of the IG7600 system have an associated User Password. The Password
is applied to Voice Mail service, and some system feature settings (Phone Lock, COS
Following, DISA, Forward, Restore to Default, Feature Button Reset).
The Extension Password is 4-digit length. The default is “0000”.
3.21 Fax/Modem
IG7600 supports FAX/modem tone detection and auto-fallback to G.711. IG7600 also
support to use T.38.
3.22 Flash – Analog Port (SLT) Flash Recognition
Flash is the momentary operation of the hook-switch at the analog device, which can be
deciphered by the IG7600 system in such a way that the previous call in progress is held,
or placed in a status of transfer awaiting further instructions from the user.
3.23 Hold Recall Time
If a call is been hold for a long time, longer than the “hold recall time”, IG will ring the IP
Phone that holds the call.
PS:
1 How to set Hold Recall Time? Please refer to section 6.6.3.3 Transmission.
2 This function works only when the IP Phone enables hold reminder on its
webpage as below.
Copyright 2013 Tecom, Co. LTD. All rights reserved Page 14 of 127