MOCET IG7600 - Manual (Page 99)

IG7600 Administration Manual
Ring Abandon Time: It specifies the maximum time between valid ring signals from
the CO/PBX. If the duration between rings exceed the Ring Abandon time, IG7600
stops ringing the destination(s) and the port returns to idle. The timer range is 1 to 10
seconds on 1 second increments.
Release Guard Time: The guard time to ignore the noise signal when releasing the
call. The timer range is 1.0 to 3.0 seconds on 0.5 second increments.
Busy Tone Detection Time: System detects the busy tone to monitor the call status.
When it reaches the detection time, system assumes the remote party hangs up. The
ongoing call will be terminated. When setting the time to “0”, the Busy Tone detection
will be disabled.
6.6.3.4 SMDR
SMDR (Station Message Detail Recording) will take down user’s dialing record. It
contains every calling period. From the log of SMDR, the administrator can charge some
fees from the user.
This page allows you to view the SMDR record and configure the SMDR. Click “View
SMDR” button to view the SMDR record, and click “Configure SMDR” button to configure
the SMDR. (Figure 6-68, Figure 6-69, Figure 6-70)
Figure 6-68. Voice – System – SMDR
Copyright 2013 Tecom, Co. LTD. All rights reserved Page 93 of 127