Pitney Bowes MapMarker USA - Manual (Page 40)

Modifying the MapMarker Installation
MapMarker USA 25
40
User Guide
Note that you can still use CASS Mode with or without Suite Link . Only the CASS reporting feature is
subject to the Suite Link USPS requirement.
To add Suite
Link
files to your MapMarker USA installation, do the following:
1. Insert the media into your drive.
2. Open the ASCII folder and copy the file in that folder into the Data directory (typically
<install>/MapMarker_USA_v25_Data). Copy the file only, not the folder.
Modifying the MapMarker Installation
After you have installed MapMarker, you can run the Install program to modify the MapMarker
installation. For example, you may want to add tools that you are licensed for but did not previously
install. Or you may want to remove features that you had previously installed. These changes are
characterized as modifications.
L
To modify your installation, you must use the same installer program that was originally used
to install MapMarker. If you use a different installer program (for a different version of
MapMarker) you will not be able to modify the installation.
A modification is distinct from an upgrade. With an upgrade, currently installed software and/or data
components are updated to their latest version. A modification adds features to or removes features
from the currently installed version.
L
Some things cannot be modified, such as the paths for software and data.
Since MapMarker is already installed on your system, the install program opens to the Introduction
dialog. This bypasses the Licensing dialog, since you have already accepted the License
Agreement. You can then proceed to modify your installation.
Modify Using the Graphical Interface on page 40
Modify Silently on page 41
Modify Using the Graphical Interface
To modify your MapMarker installation, do the following:
1. Start the installer as described in step 1 of Install Using the Graphical Interface on page 33 .
2. At the Introduction dialog, click Next.
3. In the Licensing dialog, enter the location of your license file, then click Next. For a modification,
this information is already populated in the dialog.
4. The Choose Install Set dialog appears and shows a checked box for every MapMarker feature
that is installed. This is where you can install licensed features that you previously chose not to
install, or uninstall selected features. Do the following: