Pitney Bowes MapMarker USA User Manual
Page 46
Client Workstation Install
MapMarker USA 25
46
User Guide
4. You can click Next to accept the default destination folder or click Change to display the Change
Current Destination Folder dialog and navigate to another location. Click OK in the Change
Current Destination Folder dialog when you have specified the new location, then click Next to
continue.
5. In the Licensing dialog, enter the location of your license file (.lic file), which you recorded before
starting the installation. You should have received this license file from your Sales
Representative and copied it to your local machine.
In this example, the mmusa_CLIENT-MACHINE.lic file is selected.
L
If you have an enterprise license, you can use the Setup.INI file to point to the .lic file. In
that case, you will skip over the Licensing dialog. See
6. If you have entered a valid license file, you will see the Ready to Install the Program dialog. Click
Install. If you did not enter a valid license file, you will receive an error message. See
Troubleshooting License File Errors on page 31
for information on interpreting license file
errors messages.
7. When the installation wizard completes, click Finish.
All the components necessary to run the MapMarker Desktop Application using the shared Address
Dictionary are installed.
L
During a shared Client Desktop installation, the specified license file is copied into the
MapMarker <Install> folder. The license file remains in that folder after an uninstall.
To uninstall the client application, from the Control Panel select the Add or Remove Programs
utility. Select MapMarker 25 Desktop and click Change/Remove.