Rocktron Blue Thunder - Manual (Page 24)

Functions and Parameter Descriptions
This parameter is used to select whether the Source 2 input will be the VOICE 2 output from
the previous effect in the signal chain or the DIRECT signal. In configurations where there is
no effect immediately preceding the delay, both Source 1 and Source 2 will be the direct signal.
The DELAY HIGH FREQUENCY DAMPING parameter controls the amount of high fre-
quency content in the delayed and regenerated signals. Higher amounts of damping will result
in less high frequency information in the delayed signal.
The DELAY OUT 1 parameter determines the volume of Delay 1.
The DLY PAN1 parameter allows you to pan the Delay 1 signal to the left or right channel.
The DELAY TIME1 parameter determines the length of time (in 10 milliseconds increments)
after the input signal that the Delay 1 signal will begin. The DELAY TIME can be adjusted via
the PARAMETER ADJUST control, MIDI controller changes or via the Tap Delay feature.
The FINE 1 parameter allows for adjustment of Delay 1 in 1 millisecond increments.
The DLY RGN 1 parameter determines how many times the Delay 1 signal is fed back into the
input and repeated.
The DELAY OUT 2 parameter determines the volume of Delay 2.
The DLY PAN2 parameter allows you to pan the Delay 2 signal to the left or right channel.
The DELAY TIME2 parameter determines the length of time (in 10 milliseconds increments)
after the input signal that the Delay 2 signal will begin. The DELAY TIME can be adjusted via
the PARAMETER ADJUST control, MIDI controller changes or via the Tap Delay feature.
The FINE 2 parameter allows for adjustment of Delay 2 in 1 millisecond increments.
The DLY RGN 2 parameter determines how many times the Delay 2 signal is fed back into the
input and repeated.
The SPILLOVER parameter determines whether delays from the current preset will "spill over"
into the next preset when it is recalled. Select ON to have the delay spill over into the next
preset. Select OFF to bypass the spill over feature.
SOURCE 2
DLY HF DAMP
DELAY OUT 1
DLY PAN1
DLY TIME1
FINE 1
DLY RGN 1
DELAY OUT 2
DLY PAN2
DLY TIME2
FINE 2
DLY RGN 2
D>SPILLOVER
Note!
When delays from the current preset are spilled over into the next preset recalled (i.e. SPILLOVER
"ON"), the delay parameters for the new preset will be changed to match those of the previous
preset (except for the DELAY I/O and SPILLOVER parameters) - even if the Delay effect is
switched "OUT" in the previous preset.
The EFFECT LEVEL parameter in the next preset recalled does not change, therefore delays
spilled into it may be of higher or lower volume - depending on the EFFECT LEVEL setting in
each preset.
Also, recalling the same preset twice via MIDI will cancel the Spillover effect and reset the new
preset to its stored parameter values (only when the SPILLOVER parameter in the recalled
parameter is set "OFF").
21