Rocktron Blue Thunder - Manual (Page 50)

Operating the Blue Thunder
Step 5 Turn the PRESET control on the transmitting Blue Thunder to the preset that is to be dumped
into the receiving Blue Thunder. As the PRESET control is turned, the preset number will be
displayed in the first three characters of the display.
32 PR DUMP/LOAD
Step 6 Use the PRESET control on the receiving Blue Thunder to select the preset location to store
the received preset. (The preset currently stored at the selected location will be lost when the
new preset is received, therefore caution should be used when selecting a preset location.)
122 PR DUMP/LOAD
Step 7 To initiate the dump, press the STORE button on the transmitting Blue Thunder. The transmit-
ting Blue Thunder will display the preset number being dumped and "DUMPED". The
receiving Blue Thunder will display the preset location being stored to and "RECEIVING..."
while it receives and stores the preset parameters and title.
122 RECEIVING... 32 DUMPED
After all the information for the dumped preset is stored, the receiving Blue Thunder will
display "LOADED". The receiving Blue Thunder also recalls the loaded preset at this time so
that it may be verified.
122 LOADED
Note: If there is an error in transmission, the unit will display "RECEIVE ERROR". Should
this occur, check connections and try again. If other errors occur, check the Error
Messages chart in the Appendix.
RECEIVING BLUE THUNDER
TRANSMITTING BLUE THUNDER RECEIVING BLUE THUNDER
TRANSMITTING BLUE THUNDER
RECEIVING BLUE THUNDER
47