Rocktron Blue Thunder - Manual (Page 51)

To dump a single Blue Thunder preset into a sequencer
Operating the Blue Thunder
Note: When performing data dumps to and from the Blue Thunder, always perform the dump in real
time sequence mode. This will ensure that data loaded back into the Blue Thunder is not sent
faster than the Blue Thunder can receive it.
Also, make sure that the sequencer's MIDI filter is set to accept SYSX information.
Connect a standard MIDI cable from the MIDI OUT of the transmitting Blue Thunder to the
MIDI IN on the receiving sequencer. Step 1
Step 3 Turn the FUNCTION SELECT controls on the transmitting Blue Thunder until "MIDI
DUMP/LOAD" is displayed.
Step 4 Turn the PARAMETER SELECT control on the transmitting Blue Thunder until "BULK
DUMP/LOAD" is displayed.
MIDI DUMP/LOAD
BULK DUMP/LOAD
TRANSMITTING BLUE THUNDER
TRANSMITTING BLUE THUNDER
Step 5 Start the sequencer recording.
RECORD
48
Press the EDIT button to enter the “EDIT MODE”
EDIT MODE
Step 2