Rocktron Vendetta 100W 2x12 Combo Amp - Manual (Page 4)

- 4 -
11. GAIN 3 control
Adjusts the amount of drive for Channel 3. Higher settings increase distortion and
sustain. British grind to EVH one.
12. GAIN 4 control
Adjusts the amount of drive for Channel 4. Higher settings increase distortion and
sustain. The "hot rod" version of Channel 3.
13. BRIGHT switches
Increases "sparkle" and "bite" of the channel.
14. BASS, MID,TREBLE and PRESENCE controls
The BASS, MID and TREBLE controls are your classic British bridge-T configuration
(found in most of the popular guitar amps throughout history). The PRESENCE
control allows you to tailor the high frequency response to suit your taste.
Experiment...try new things. There are many great tones at your fingertips!
15. VOICING switch
Selects VINTAGE or MODERN. This switch affects both Channel 3 and Channel 4.
16. PRESENCE control
Tailors the high frequency of the channel. This control affects both Channel 3 and
Channel 4.
17. MASTER 3 control and channel on LED
Adjusts the overall volume of Channel 3 only and indicates the channel is active
when LED is lit.
18. MASTER 4 control and channel on LED
Adjusts the overall volume of Channel 4 only and indicates the channel is active
when LED is lit.
19. MAIN LEVEL control
This is a master level control which determines the overall output level of the
VENDETTA.
20. EFFECTS control
When using the parallel loop , this control adjusts the amount of effects that will be
mixed with your direct signal.
21. PRESENCE control
This is a master PRESENCE control which tailors the overall high frequency at the
outputs of the VENDETTA.
22. DENSITY control
This is a master DENSITY control which determines the overall fatness of the
VENDETTA.
23. POWER switch
This is the MAINS AC power switch. When powering up the VENDETTA, verify that
the STANDBY switch (24) is in the "OFF" position.
24. STANDBY switch
After powering up the VENDETTA, allow one minute to allow the circuits to stabilize
then switch to the "ON" position.