Operating precautions, Rear panel cont – Rocktron Vendetta 100W 2x12 Combo Amp User Manual
Page 6
- 6 -
Rear Panel cont......
9. SERIES LOOP - SEND jack
This 1/4" jack connects to the INPUT of an effects device.
10. SERIES LOOP - RETURN jack
This 1/4" jack connects to the OUTPUT of an effects device. Inserting a plug into this jack
automatically activates the effects loop circuit.
11. PARALLEL LOOP - SEND jack
This 1/4" jack connects to the INPUT of an effects device.
12. PARALLEL LOOP - RETURN jack
This 1/4" jack connects to the OUTPUT of an effects device. Inserting a plug into this jack
automatically activates the effects loop circuit and the front panel effects loop control.
Operating Precautions
Please note the following precautions before operating your VENDETTA:
*
Always use the MAIN SPKR jack first for the speaker connection.
*
Do not operate below 4 ohms.
*
Never operate the VENDETTA without a load on the output. Always have a
speaker cabinet plugged into the speaker output before turning on the unit.
*
Always be certain to use speakers or speaker cabinets capable of withstanding
the power that the VENDETTA is capable of providing. Rocktron is not responsible
for speaker failure resulting from the use of this equipment.
*
Always plug and unplug speaker outputs with the power amplifier OFF.
Temperature Considerations:
*
Note that the power tubes at the rear of the VENDETTA generate considerable
heat when operating the amplifier.
DO NOT TOUCH THESE TUBES DURING
(OR SOON AFTER) OPERATION! Failure to heed this warning may result
in severe burns!
*
Always keep well ventilated. Do not block the top vent.
*
Do not let cables rest on power tubes.