Rocktron Vendetta 100W 2x12 Combo Amp - Manual (Page 5)

- 5 -
Rear Panel
1. POWER INLET module
The Power Inlet module accepts the detachable power cord included with the unit,
and also houses the main power fuse and voltage selector.(Always replace with the
Slow-Blow fuse indicated on the rear panel.)
2. HT FUSE
This fuse provides internal protection in the event of a power tube failure. Always
replace with the same type and rating.
3. FOOT CONTROLLER section
See page titled MIDI/Switching Section for a detailed operation of the MIDI and
channel-switching functions.
4. POWER TUBE TEST POINTS
This feature provides a convenient point for measuring the idle current in the power
tubes without disassembling the unit (requires amp meter). Different tube types can
be used by readjusting the bias. Please see section on "Power Tube Test Points" for
additional information.
5. IMPEDANCE switch
This switch selects the proper impedance to match the output of the amplifier to the load.
(See the section on Impedance Settings for more details).
6. MAIN SPEAKER output
This jack connects to the internal speaker on the COMBO version of the VENDETTA or to the
primary speaker in a head/cabinet setup. A speaker must always be connected to this jack.
7. EXTENSION SPEAKER output
This jack is used to connect additional speakers to combo or when multiple cabinets are used
with the head version of the VENDETTA.
8. SLAVE OUT jack
This 1/4" mono jack provides a FULL RANGE direct output after the power amplifier stage.
It is intended to be used as an output to feed an external effects system or to an additional
powered speaker system. It is not a RECORDING output.