Desa P324 - Manual (Page 15)

108660
15
15
For more information, visit www.desatech.com For more information, visit www.desatech.com
Note: Glass door may be heavy for some individuals. If this is the
case, please request help from someone else.
These B-vent fireplaces are approved for use with optional bi-fold glass
doors (see Accessories, page 27). The glass panels may be ordered and
installed anytime after the fireplace installation is complete.
Follow these steps to install left and right panels:
1. With the handle at the bottom, completely fold the panel on its
hinges.
2. With the handle facing the center of the firebox opening, insert
the lower pivot pin on the glass door panel into the hole in pivot
plate on the bottom edge of the fireplace opening (see Figure 32).
3. Keeping the folded door tilted, slide the upper two pins into
the guide track found under the upper facial edge of the fire-
box opening.
4. Tilt the door assembly fully vertical until the outer pivot pin
snaps into the mounting hole in the upper spring clip (see
Figure 32).
5. Once the top and bottom pins are secured, unfold the door into
the closed position.
6. Repeat the process for the opposite door assembly.
7. To adjust the doors, slide them partially open. Using a screw-
driver, loosen the hold-down screws in the spring clip (see Fig-
ure 33) and pivot plate.
8. Close both doors until evenly joined at the middle and note the
gap at the outer edges of the face.
INSTALLING OPTIONAL GLASS DOOR
ACCESSORY
CAUTION: Use only glass doors certified for use
with this appliance.
INSTALLATION
Continued
Figure 32 - Installing Optional Glass Door
Spring Clip
Insert Pin Into
Spring Clip
Insert Bottom
Pivot Pin Into
Pivot Plate and
Swing Door Into
Vertical Position
Pivot Plate
Slide Top
Pin Into
Door Track
INSTALLATION
Installing Optional Glass Door Accessory
9. Reopen one door at a time and retighten the upper and lower
hold-down screws.
10. Repeat the process until both doors are evenly joined, spaced
and working freely.
CAUTION: The glass panels become very hot while the
appliance is operating. Do not attempt to adjust or clean
the glass doors until the appliance has fully cooled.
The doors may be removed for replacement or cleaning as follows:
1. Partially open the door and press up on the upper spring clip with
a screw driver until the outer top pivot pin is free of the clip.
2. Fully fold the frame assembly and slide the upper edge to-
wards the center of the firebox opening until the guide pins are
free of the frame rail (see Figure 34).
CAUTION: Always operate the appliance with the
doors either fully opened or fully closed. Operating
the appliance with the doors partially open can result
in improper venting of flue products.
Figure 33 - Adjusting Glass Doors
Spring Clip Hold-Down
Screw
Side Front
Face
Partially
Opened
Door
Figure 34 - Removing Glass Doors
Spring Clip
Depress Spring
Clip to Release
Pivot Pin
Remove
Bottom Pin
From Pivot
Plate While
Sliding Door
Out of the
Upper Track
Pivot Plate
Fold Bi-Fold
Door After
Releasing
Spring Clip and
Slide Door Out
of Upper Track