Denon AVR-3805 - Manual (Page 26)

26
Check of the measurement results
1 Select the items.
The measurement results of each item can be
checked here.
CH SEL
ENTER
(Main unit) (Remote control unit)
CH SEL
ENTER
S p C o n f i g . C h e c k
* A u t o S e t u p
2 Press the ENTER button and display
the verification screen.
CH SEL
ENTER
(Main unit) (Remote control unit)
CH SEL
ENTER
[Speaker Config. Check] [Delay Time Check] [Channel Level Check]
3 If the check ends, press the ENTER button again.
CH SEL
ENTER
CH SEL
ENTER
(Main unit) (Remote control unit)
Select from the following three items based on the
measurement results.
• Set with the checked measurement value.
• Perform the measurement again.
• Cancel the checked measurement value.
S t o r e
* A u t o S e t u p
4
CH SEL
ENTER
(Main unit) (Remote control unit)
CH SEL
ENTER
When the “Store” is selected, all parameters are
stored up .
When the “Retry” is selected, it measures again. 5
CH SEL
ENTER
(Main unit) (Remote control unit)
CH SEL
ENTER
NOTE:
• When measurements have been made using the
measurement microphone, speakers with a built-
in filter such as subwoofers might be set with a
value that differs from the physical distance
because of the internal electrical delay.