Denon AVR-3805 - Manual (Page 74)

74
NOTE:
• There are four Dolby Surround Pro Logic modes (NORMAL,
PHANTOM, WIDE and 3 STEREO). The AVR-3805 sets the
mode automatically according to the types of speakers set
during the system setup process (page 32).
4 Select the play mode.
CH SEL
ENTER
CH SEL
ENTER
(Main unit) (Remote control unit)
(Pro LogicII Cinema mode) (Pro LogicII Music mode) (Pro LogicII Game mode) (Dolby Pro Logic mode)
M O D E : P L I I G
* S u r r P a r a m e t e r
M O D E : P L I I C
* S u r r P a r a m e t e r
M O D E : P L I I M
* S u r r P a r a m e t e r * S u r r P a r a m e t e r
M O D E : D O L B Y P L
5 Select the parameter to change. (See “Surround parameters q” for a description of each parameter.)
CH SEL
ENTER
CH SEL
ENTER
(Main unit) (Remote control unit)
When set with the on-screen display using the remote
control unit while in the MUSIC mode, set the “
” mark
to “OPTION 0” using the D and H cursor buttons, then
press the F cursor button.
Press the ENTER button to return to the previous screen.
6 Set the various surround parameters.
CH SEL
ENTER
CH SEL
ENTER
7 If the setting ends, press the “ENTER” or “SURROUND
PARAMETER” button.
Display
• When the “SB CH OUT” parameter is set to “ON”.(Set “SP.Back” at the system set up to “1spkr” or “2spkr”).
M O D E : P L I I x C
* S u r r P a r a m e t e r
M O D E : P L I I x M
* S u r r P a r a m e t e r
(Pro LogicIIx Cinema mode) (Pro LogicIIx Music mode)
M O D E : P L I I x G
* S u r r P a r a m e t e r
(Pro LogicIIx Game mode)
Display
• When the “SB CH OUT” parameter is set to “OFF”.(Set “SP.Back” at the system set up to “None”).
Ex : DOLBY PLIIx music mode screen.
(Main unit) (Remote control unit)
The on-screen display differs according to whether the operation is
performed from the main unit or the remote control unit.
3 Set the surround parameter mode.
(Main unit) (Remote control unit)
M O D E : P L I I x C
* S u r r P a r a m e t e r
NOTE:
• The PLIIx mode is set when the “SB CH OUT” surround
parameter is set to “ON”, and the PLII mode is set when this
parameter is set to “OFF”.