VDO M3WL - Manual (Page 23)

23
M3 WL
Settings – wheel circumference/wheel size
Manual setting by entering the roll circumference
in millimetres/inch
For mm: The first two digits (in the example “21”) flash.
Press the
BIKE button to set these digits to the desired
value.
For Inch: The Inch value is Flashing.
Press the
BIKE Button to set the digits to the desired value.
Press the SET button to confirm your setting.
For mm: The third digit now flashes and is ready to be set.
Press the
BIKE button to set this digit.
Press the SET button to confirm your setting.
For mm: The final digit on the right now flashes.
Press the
BIKE button to set this digit.
Press the SET button to confirm your setting.
Your wheel circumference setting is now complete.
The response
“Set OK” appears on the display.
If you want to configure further settings,
press the
BIKE button to access these.
If you do not want to configure any further settings,
press and hold the SET button.
The settings menu closes.
The VDO M3 WL returns to function mode.
mm-Setting Inch-Setting