Fcc-addendum ic-addendum – VDO M3WL User Manual

Page 40

background image



EU declaration of conformity

Correct disposal of this product (electrical waste)

(To be used in EU countries and other European
countries with a separate collection system). The
labelling on the product and the relevant literature

indicates that it must not be disposed of with normal house-
hold waste at the end of its service life. Please dispose of
this device separately to other waste so as not to harm the
environment or human health through uncontrolled waste
disposal. Recycle the device to promote the sustainable reuse
of material resources. Private users should contact the retailer
from whom they purchased the product or the responsible

authorities to find out how they can recycle the device in
an environment-friendly manner. Commercial users should
contact their suppliers and consult the conditions of the sales
agreement. This product must not be disposed of with other
commercial waste.

We, CYCLE PARTS GmbH, Le Quartier Hornbach 13, D-67433
Neustadt/Weinstraße, declare that when used as intended,
the VDO cycle computer with wireless transmission
VDO M3 WL and the transmitter D3-SPD comply with
the essential requirements established in Article 3 of the
R&TTE Directive 1999/5/EC.

The declaration of conformity can be viewed at:

Neustadt, October 2013



This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference,
(2) this device must accept any interference received,

including interference that may cause undesired


NOTE: This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to part 15
of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is
no guarantee that interference will not occur in a particular

This device complies with Industry Canada licence-exempt
RSS standard(s).
Operation is subject to the following two conditions:
(1) This device may not cause interference,

If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:

– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and
– Connect the equipment into an outlet on a circuit different

from that to which the receiver is connected.

– Consult the dealer or an experienced radio/TV technician

for help.

Changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to
operate the equipment.

(2) this device must accept any interference,

including interference that may cause undesired

operation of the device.

This Class digital apparatus complies with Canadian