VDO WL MC 2.0 - Manual (Page 58)

MC 2.0 WL VDO CYCLECOMPUTING 58
DE ENG FR ES IT NL PL
5.2 Installing the battery in the computer >>> P07
5.3 Inserting the computer into the handlebar bracket >>> P08
Your VDO computer comes without battery built in.
Before you start, please insert battery.
Step 1 Open the battery compartment lid with a coin.
Step 2 Place the battery in the computer casing with the +terminal
pointing up.
Step 3 Make sure that the battery does not tilt.
Step 4 Ensure that the rubber seal lies flat on the battery
compartment lid.
The VDO twist-click system securely connects the computer to the
handlebar bracket.
Step 1 Place the computer into the bracket in a 10 o'clock position.
Step 2 Twist the computer to the right until reaching the 12 o'clock
position and click it into the bracket system.
Step 5 Insert the battery compartment lid into the opening and use
a coin to turn it to the right as far as it will go (approx. ⅓ turn).
Step 6 After inserting the battery, the computer will start the language
select-mode. See chapter 6.1
TIP for changing batteries: VDO recommends changing the battery
annually. Buy a new battery in good time to ensure the wireless
transmission works perfectly. When the battery is changed,
all settings and all trip totals are saved.
Step 3 To remove the computer, twist it to the left
(do not push or pull).
How to remember: Rigid to the Right, Loose to the Left
Step 5 Guide the cable ties through the slot in the handlebar bracket,
place around the handlebars or the stem and pull (do not pull tight
just yet). Step 6 If fitting to handlebars: align the computer angle to achieve
optimum readability. now pull the cable ties tight. Snip off protruding
ends with clippers.