Woodhaven 789XL: Dado Jig - Manual (Page 7)

6
14
15
14. ADJUST WORK STOPS
Adjust the Work Stops to fit the width of stock you're
using. See fig. 14. Select the workpiece you want to cut
the dado for. Loosen the Adjustable Track and place the
workpiece vertically between the 1/4" Fences. Slide the
Adjustable Track so the workpiece is sandwiched between
both 1/4” fences and tighten the knobs. Remove the
workpiece from between the 1/4" Fences and cut the dado.
See fig. 15.
Work Stops
Workpiece sets
dado width by
indexing between
1/4” Fences
16
16. Dado Jig Operation
1. Place the Router/Router Plate on the jig against
the Back Position Stop, with the Plate Guide
between the Stationary & Adjustable Tracks.
1-2. Turn the router on and hold it against the
Adjustable Track as you pull the router forward.
2-3. When you contact the front Position Stop, slide
the router to the left against the Stationary Track.
3-4. Holding it against that track, push the
router back to the Back Position Stop.
See fig. 16 & Cover.
Continued on next page
1 4
2 3