Woodhaven 789XL: Dado Jig - Manual (Page 8)

17. OTHER USES
By adjusting the Adjustable Track so the Router Plate/
Plate Guide can't move side to side between the Adjustable
and Stationary Track, you can use the jig for making
flutes, sliding dovetails and other long straight cuts.
To cut angled dadoes, install an angled sub-fence to the
clamp pads of the jig. To do this, drill a hole in each pad
and attach the sub-fence to them with wood screws after all
other adjustments have been made. You'll have to clamp
the stock and the jig to the workbench separately. Note
that an angled sub-fence will limit the width of stock that
can be dadoed. You'll want to slide the edge fence as close
to the narrow (pointed) end of the sub-fence to maximize
the stock width that can be dadoed. See fig. 17 & 18
18. DADO JIG STOP ACCESSORIES
The Front Track of the Dado Jig can be extended on
one or both ends. The extension can be ordered in twelve
inch increments (4424XL - 24” extension shown) all the
way up to 96” long. This allows you to attach Work Stops
to the extra length of track to make cutting multiple dadoes
easier. Please note the extension does not come with a stop
by default, you must order them separately. You can order
as many Work Stops (789S) as needed. See fig. 19 & 20
An additional accessory to our Dado Jig Extension is
the 4523 Micro Adjuster. It attaches directly to the 789S
stop and allows up to 5/8" of fine adjustment. See fig. 20
©Copyright WOODHAVEN INC. 10/2/07
(800) 344-6657 or WWW.WOODHAVEN.COM
7
17
18
19
20
4424XL with two
789S stops
4424XL
789S
789S with 4523
Micro Adjuster