Indication, Show lamp! function, Firmware upgrade – XAIRCRAFT FC1212-P User Manual

Page 28

Advertising
background image

25 / 36

x

interval (the interval between two indications)

interval

()

repeat

repeat

~

yowl (beeping always)

Solid ON

For example(buzzer): (.x) means the buzzer will short beep again and again, (-.x) means the buzzer will has a long
beep then a short beep, and repeats long beep short beep.

Indication

Buzzer

Green

Light

Blue Light Red Light Indication

.

Function Changed. When you switch the function status (change
Flight Mode, turn on/off carefree, turn on/off heading hold, etc.),
then buzzer will beep once to tell you the FC has reacts your
operation.

(..x)

RC Signal lost, that means the receiver is disconnected with the
radio. But not support all the receivers.

(..x)

Flight Mode is NORMAL.

(..x)

Flight Mode is ATTITUDE, and Autopilot is not plugged-in.

(-x)

Autopilot is plugged-in, but GPS is not available.

~

GPS is ready. Position Hold and Return to Home are available.

(……)

(……)

AHRS is disconnected.

(……)

(……)

(……)

(……)

This is a special signal that can be turn on by your radio. When
'Show Lamp!' is on, the buzzer and lights will shows this signal. It can
help you to find the copter when you lost it in the grass.

Show Lamp! Function

Turn on the show lamp function, buzzer sound faster in pilot lamp, all the lights keep flashing. Show lamp! function
is for check the pilot lamp work normal or damaged。
Turn ON show lamp! function: Configure a switch for Show Lamp! function. You can use Input6, Input7 or Input8
for it. The picture shows using Input6 for the function.

Firmware Upgrade

Upgradable Modules: FC1212-P, AHRS-S V2, AHRS-P and Autopilot.
Step 1: Before upgrade, confirm the Connect button is green and FC1212-P is connected. Click the right bottom

Advertising