Volvo 2013 XC70 - Manual (Page 310)

08 Wheels and tires
Tire Sealing System
08
308 * Option/accessory, for more information, see Introduction.
Location
Introduction
Certain models are equipped with a tire sealing
system* that enables you to temporarily seal a
hole in the tread surface and re-inflate a flat tire,
or to adjust a tire’s inflation pressure.
The system consists of an air compressor, a
container for the sealing compound, wiring to
connect the system to the vehicle’s electrical
system via one of the 12-volt sockets, and a
hose used to connect the system to the tire’s
inflation valve.
NOTE
The tire sealing system's compressor has
been tested and approved by Volvo.
The 12-volt sockets are located in the front
tunnel console, on the rear side of the center
console in the rear seat and in the cargo area*,
see page 209.
Accessing the tire sealing system
The tire sealing system is stowed under the
floor of the cargo area. To access it:
1. Lift the floor hatch in the cargo area.
2. Lift out the tire sealing system.
NOTE
• The tire sealing system is only intended
to seal holes on the tire’s tread area, not
the sidewall.
• Tires with large holes or tears cannot be
repaired with the tire sealing system.
• After use, stow the tire sealing system
properly to help prevent rattling.
WARNING
• After using the tire sealing system, the
vehicle should not be driven farther than
approximately 120 miles (200 km).
• Have the tire inspected by a trained and
qualified Volvo service technician as
soon as possible to determine if it can
be permanently repaired or must be
replaced.
• The vehicle should not be driven faster
than 50 mph (80 km/h) while using a tire
that has been temporarily repaired with
the tire sealing system.
• After using the tire sealing system, drive
carefully and avoid abrupt steering
maneuvers and sudden stops.