Pilz PNOZ mmc2p seriell - Manual (Page 20)

6.2 Preparing for operation
6 Commissioning
Pilz GmbH & Co. KG, Felix-Wankel-Straße 2, 73760 Ostfildern, Germany
Telephone: +49 711 3409-0, Telefax: +49 711 3409-133, E-Mail: [email protected]
6-2
6.2 Preparing for operation 6200 Preparing for operation 6- Betriebsbereitschaft herstellen - Schnittstelle wählen- seriell
The serial interface RS 232 is activated and detected depending on the
USB interface on the base unit:
` USB interface on the base unit not connected
In this case, the serial interface RS 232 will be detected and activated
by the base unit as soon as the communication module has been
connected to the base unit.
` USB interface on the base unit connected
If the USB interface on the base unit is already connected, the "Ex-
ternal" interface will first need to be selected on the base unit display
to enable the serial interface RS 232 on the base unit to be detected
and activated (see operating manual for the base unit for details of
the setting).
6.2.1 Download modified project to the PNOZmulti safety system
Download modified project to the PNOZmulti safety system 6- Verdrahtung_multi_Modul_Betr_geaend_Projekt_BA
As soon as an additional expansion module has been connected to the
system, the project must be amended using the PNOZmulti Configura-
tor. Proceed as described in the operating instructions for the base unit.
NOTICE
For the commissioning and after every program change, you
must check whether the safety devices are functioning correctly.