Lenco CS-430 BT - Manual (Page 10)

9
BlueTooth Handfree System:
1. Pairing
Turn on Bluetooth mode of mobile phone, then select the function for Finding Bluetooth Device and
enter it. After finishing finding, it will show the name of Bluetooth Device if found, select it and enter it,
then it will show an interface that asks you to input password. Input the password 0000 and enter it.
then the LCD of the car audio system will display BT READY and BT icon .
2. Connection or disconnection
A) Use mobile phone to do connection or disconnection
1) In connection status, find the paired and connected Bluetooth Device, then press the disconnection
button to do disconnection.
2) In disconnection status, find the paired and disconnected Bluetooth Device, then press the
connection button to do connection.
B) When powering on (after Acc of the car was switched off ), the unit will search for mobile phone, pair
and connect. This will take about 10-15 seconds.
Note:
(1) Bluetooth icon appears on LCD only when in connection status.
(2) In connection status: Mobile phone transfers to car audio player whenever a dialling takes place;
Mobile phone transfers to car audio player whenever receiving a call.
3. Dialling when in connection status
To make a call simply press the TEL button and enter the number you wish to call using the mobile
phone. When your ready to make the call press TEL again, to end the call simply press MUTE/C
button.
4. Accept/ Reject/ End Call
A) During ringing, press TEL button to accept the call.
B) During ringing, press CLEAR button to reject the call.
C) During talking, press CLEAR button to end the call.
5. Talking volume level setting
Whlie talking, use volume control to adjust volume level, but this volume level can not be saved.
6. Dialling or receiving calls while the unit is in sleep mode
When the car radio is in standby mode (Acc on and Power off), when dialling or receiving a call, the
car radio will power on automatically.
After the call is completed, the radio will revert to standby mode.