Lenco CS-430 BT - Manual (Page 6)

5
(2) PI SOUND/ PI MUTE:
PI SOUND mode: If a car is cruising between buildings, an oscillation phenomenon may occur, due
to different PI codes being received from the same AF.
PI MUTE mode: In above situation, the sound will be muted for less than 1 second.
(3) RETUNE L / RETUNE S:
The initial time of automatic TA search or PI SEARCH mode is selected.
When PI information is not received during retune time , the radio start to retune to next same
PI station.
When same PI station is not received during 1 cyclic search, the radio goes to last station
and waits for 4-5 minutes until PI code is received.
RETUNE L mode: selected as 150 seconds.
RETUNE S mode: selected as 90 seconds.
(4) MASK DPI/MASK ALL:
MASK DPI mode: masked only the AF which has different PI.
MASK ALL mode: masked the AF which has different PI and NO RDS signal with high field strength.
BEEP ON mode: The beep is generated when any key is pressed.
BEEP OFF mode: The beep sound is disabled.
(6) VOL LAST/VOL DEFA
VOL LAST: The volume level when switching off will be restored with power On.
VOL DEFA: The volume level of the main unit after power on is a constant value.
When selecting VOL DEFA item, press SEL button to display AVOL ,
then you can pre-set the constant volume level after power on with VOL control.
(7) CLK ON/OFF
CLK ON: Clock will always show on the display when power is off.
CLK OFF: Clock will disappear from the display when power is off.
6. To display and adjust clock
Press CLK button briefly to display time for 5 seconds on the display, and then returns to its previous
display unless the button is pressed again.
Press CLK button and hold for more than 1 second until the real time flashes on LCD. Then you can
adjust HOUR or MINUTE with volume control .
7. To remove front control panel
Press RELEASE button to release front control panel from unit chassis, then you can remove it from
unit chassis.
When front control panel is removed, the LED indicator on front cabinet flashes.
8. To reset unit
Before operating the unit for the first time, or after replacing the car battery or changing the
connections. You must reset the unit.
To reset the unit, remove the front control panel, then press RESET button with a cuspidal object.
This operation will erase clock setting and some stored contents.