Lenco CS-430 BT - Manual (Page 5)

4
Common operation:
1. To turn the unit on/off .
When the unit is power Off, it may be switched On by pressing any button except RELEASE button.
When the unit is switched On, press and hold POWER button for more than 0.5 second, to switch the
power off.
2. To select function mode
Press MODE button to change function mode as follows:
-->RADIO -->USB(after inserting USB stick)-->CARD(after inserting SD card)
-->BT-->AUX-->
When there is no media (USB/CARD), that mode will be skipped.
3. To adjust the volume level
Rotate VOL knob or press + or - button to adjust volume level during playback.
4. To mute or resume sound
Press MUTE or MU button to eliminate or resume sound immediately during playback.
To resume the sound immediately, you can also press SEL, VOL, +, -, -10, +10, TOP,
PLAY, >>| and |<< buttons(knob).
5. To set sound mode and menu
1).To set sound mode:
Press SEL button shortly and repeatedly to select mode of VOL(volume), BASS
(without preset DSP), TRE(treble)(without preset DSP), BAL(balance) and FAD(fader)
in the sequence and circulation. In each mode, the waiting time is about 5 seconds,
and when the waiting time is over, it will return to the last display mode.
After selecting a sound mode, use volume control to set level of the selected sound mode.
2).To set menu:
Press SEL button and hold for more than 2 seconds to turn on TA SEEK/TA ALM mode,
then press SEL button shortly and repeatedly to select PI SOUND/PI MUTE, RETUNE L/RETUNE S,
MASK DPI/MASK ALL, BEEP ON/BEEP OFF, USER SET (FLAT/CLASSIC/ROCK/POP),
VOL LAST/VOL DEFA , STEREO/MONO(in RADIO mode), LOUD OFF/LOUD ON,DX/LOCAL
(in RADIO mode), CLK ON/CLK OFF, CLK 12/24 mode.
After selecting a desired item, use volume control to set.
(1) TA SEEK/TA ALM:
TA SEEK mode: when newly tuned station does not receive TP information for 5 seconds, the radio
retunes to next station which has not the same station(PI) as the last station, but has the TP
information.
When TP information gets lost at the current station for retune time which is set by RETUNE
SHORT(90 seconds) or RETUNE LONG(150 seconds), the radio start to retune to next same PI
station. When same PI station is not received in 1 cyclic search, the radio retunes to next station with
TP information.
TA ALARM mode: when this mode is selected, any automatic retune mode is not activated.
Only double beep sound(ALARM) is out-put.
When newly tuned station does not have TP information for 5 seconds, beeps are sounded.
When TP information gets lost at the current station for retune time, the beep sound is out-putted.
When newly tuned station has no RDS signal, PI SEEK may be suppressed.