Lenco IPD-5100 - Manual (Page 6)

10 11
Eng Eng
Radio Tuner Operation
Notes :
1. There is a few seconds delay when programming, after this delay time,
the unit will automatically switch back to normal tuner mode.
2. You can overwrite a preset station by overwriting and storing the new
frequency in its place.
1. Press the POWER button to turn on the unit, where the power status
indicator light on.
2. Press the FUNC button to select FM stereo or FM mono radio receiving
mode.
3. Press the PRESET button. The preset channel number and PRESET
indicator appear on display.
4. To select desired preset station, press the button.
Recalling Preset Station
CH /
EQ setting :
The unit is designed to have four EQ presets for your selection , the
CLASSIC , JAZZ, ROCK and POP .
You can select the desired effect by pressing the "EQ" button repeatedly at
following sequence :
CLASSIC JAZZ ROCK POP
OFF (or BASS/TREBLE, if previously set)
Bass setting :
1. Press and hold the EQ button entering Bass setting mode, the "BASS"
indicator blinks on display.
2. To select desired bass level, press the CH / button.
Treble setting :
3. Press the EQ button again entering Treble setting mode, the "TRE" indicator
blinks on display.
4. To select desired treble level, press the button. CH /
Set Loudness on or off
5. Press the EQ button then press CH
/ button to set loudness on or off.
6. Press the EQ button to exit bass/treble and loudness setting mode.
EQ preset , Loudness, Treble and Bass Setting
Radio Broadcast System Selection
In case the unit is moved to other countries with slightly different radio
broadcast system, the unit allows you to select USA, EU, Australia and
Japan systems.
1. Set the unit to Power Off mode.
2. Press the MODE button repeatedly until the flashing indicator US, EU,
or JP is seen.
3. Press the VOLUME +/- button to select one of the broadcasting systems.
4. Press MODE button to save the setting and exit the setting mode.
The followings are the specifications of the three radio broadcast systems:
- USA's Radio Broadcast System
FM 87.5 108 MHz, 0.1 MHz tuning step
- AU and EU's Radio Broadcast System
FM 87.5 108 MHz, 0.05 MHz tuning step
- Japan's Radio Broadcast System
FM 76.0 108 MHz , 0.05 MHz tuning step
"AU"
NOTE: