Lenco IPD-4600 - Manual (Page 10)

Radio Tuner Operation
Manual Preset
Press the button on main unit or press STANDBY button on remote
control to turn on the unit.
2. To select FM radio mode, press the FUNC button on main unit (or the RADIO
button on remote control) repeatedly until the radio indicator "FM" is shown on
the LCD display.
3.
4.
5.
6.
7.
1.
Tune to the radio station you want to store in memory by using the TUNE +/-
Press the MEM button. The preset channel number appears on display and is
To select desired preset station number, press the CH +/- button.
To confirm preset location, press the MEM button.
Repeat steps 3 to 6 above to store other stations, if apply.
Notes : You can overwrite a preset station by overwriting and storing the new
lace.
blinking.
button from the remote control or TUNE button form main unit.
frequency in its p
FM Antenna
Fully extend the FM antenna wire for the best FM radio reception.
Radio Tuning
Press the button on main unit or press STANDBY button on remote control
to turn on the unit.
2.
1.
3. If necessary, press the ST/MO button from the remote control to select FM stereo
or FM mono radio reception.
4. To manually tune to a desired station, repeatedly press the TUNE +/- button from
the remote control or TUNE button from main unit.
5.
Notes :
Manual tune to select weaker stations that might be skipped during automatic
tuning.
Radio Preset Stations
The units allows you to store up to 20 FM stations for easy recall at any time.
TUNE button in the main unit can tune radio freguency up only.
To select FM radio mode, press the FUNC button on main unit (or the RADIO
button on remote control) repeatedly until the radio indicator "FM" is shown on the
LCD display.
To automatically search for stations with strong signals, Long press the TUNE +/-
button from the remote control until the frequency digits on display begins to scan
then release the button. The tuner will stop on the first strong signal it finds.
If the automatic tuning does not stop on the exact frequency of the station, for
example, it stops on 100.9 MHz instead of 100.8 MHz, use the manual tuning
method to "fine tune" to the exact frequency of the desired station.
10