Lenco IPD-4600 - Manual (Page 13)

The unit incorporates dual alarm function which wake you up from Buzzer (Beep), FM
Alarm Setting
Radio or iPhone / iPod.
Alarm Operation
13
Note: Following settings are implemented from the remote control.
Set the alarm time
1. Turn off the unit.
2. Press the ALARM 1 (ALARM 2) SET button and the alarm time digits and alarm
indicator ( ) blink.
3. Press the HR button to set alarm hour.
4. Press the MIN button to set alarm minute.
Select wake up alarm source
5. Press the ALARM 1 (ALARM 2) SET button again, alarm source indicator blink.
6. Press the Up / Down button to select alarm source BUZZ (buzzer), RADIO
(radio) or IPHONE (iPhone/iPod).
Save settings and activate alarm
7. To save all settings and auto-exit the setting mode, wait for a few seconds.
8. To activate the daily alarm, press the ALARM 1 (ALARM 2 ) button and the
corresponding alarm source indicator appears on the LCD display.
Notes:
-If "Wake to iPod" is selected but your iPod has not been docked, the alarm source will
be redirected to the Alarm Buzzer automatically when the alarm is reached.
-When "Wake to Radio" is selected, make sure the radio station which you want to wake
to is tuned.
-To activate the daily alarm, the corresponding alarm 1 or alarm 2 indicator should
appear on the display.
1 2
1 2
1 2