Lenco LED-2217 User Manual

Page 22

Advertising
background image

21

Highlight the LNB Type , and use the

buttons and Ok

to enter submenu then you c

rameters.

KHz: The level of the LO switch / DS switch ( Require
the user to have installed 22KHzSatellite signal switch).
Press

to select Auto/On/Off.

Auto: Automatically issued 22 KHz pulse signal to control
switching.

On/Off: Manual control switch.

LNB Power: Polarization switching power supply, Press

to select On/Off.

On: Allowed to receive Horizontal / Vertical Polarization
program.

Off: out-off of supply.

Tone burst: Double Single Switch (Require users to install
Tone burst switch), Press

to select Burst A/Burst

B/None.

Burst A /Burst B: Manually switch the satellite A/B.

DiSEqC1.0.4: select 1 switch ( Require the user device
support DiSEqC 1.0 protocol). Press

to select LNB1/

LNB2/ LNB3/LNB4/None.

LNB1/LNB2/LNB3/LNB4: Corresponding to a satellite ,
After selecting the corresponding list will appear in the
satellite list.

DiSEqC 1.1: 16 select 1 switch ( Require the user device
support DiSEqC1 .0 protocol) Equipment needs support
DiSEqC 1.1 protocol, Most control 16 LNB. Press

to

select LNB1~LBN16/None.

LNB 1-LNB 16: Corresponding to a satellite, After select-
ing the corresponding list will appear in the satellite list.

Motor: Control of multi-satellite polar (Require the user
device support DiSEqC1.2 or DiSEqC1.3 protocol), Left
and right buttons to select DisEqC1.2/ DisEqC1.3/None.

DisEqC1.2: DisEqC1.2 Protocol selection

DisEqC1.3: DisEqC1.3 Protocol selection

For Mot

te “DisEqC1.2” , Operating Instructions:

Press RED button to enter “Set Limit" menu.

Press OK button to enter Set Position menu.

Advertising