Lenco LED-4001 - Manual (Page 12)

EN 12
GETTING STARTED
Initial Setup Initial Setup
1. Connect one end of the RF coaxial cable to
the aerial socket on the wall and the other
2. Connect the mains cable to the mains socket
3. In standby mode, press the POWER button at
the bottom of the TV or the button on the
4. The first time you turn the TV on, it will go
straight into First Time Setup
the
buttons to navigate the menu and
OSD Language
Selects your desired language to be
Mode Setting
Store Mode: For store demo, the brightness
Country
Selects the country where you will operate
Tuner Type
Selects the Tunner Type ：
Auto Scan
Selects the auto scan type: DTV+ATV / DTV
Start
Press the OK
the progress of the tuning and the number of
Press the SOURCE button on the remote
control and select DTV to switch the TV to
Information Banner
Whenever you change channel using the CH+/
CH- buttons or the number buttons, the TV
displays the broadcast picture along with an
information banner on the top left of the screen
The information banner can be displayed at
any time while watching TV by pressing the
DISPLAY
5. If you want to skip the DTV tuning, press the
MENU
may repeat the above step if you also want to
General Operation
Auto Scan
Scanning CH34
Digital Channels Found:
DTV :10 Radio :0 Data:0
Analog Channels Found: 0
MENU: Skip EXIT: Exit
First Time Setup
OSD Language
Mode Setting
Country
Tuner Type
English
Home Mode
Hungary
Antenna
Auto Scan DTV+ATV
Start
Move Adjust MENU: Return EXIT: Exit