Lenco PDR-03 - Manual (Page 10)

DAB Operation
9
Scan stations
When turning on to DAB mode, the unit will auto-scan the stations
it found in this area. Press / button to select the previous or
next stations, and press ENTER to activate to play the station.
Station tuning
Press and hold the INFO/MENU button, when the <Station scan>
appears, press ENTER, then use the / button to cycle through
the scanning options: <Full scan>, <Manual tune>.
* Select the Full scan, and press ENTER to enable a full scanning.
* Select the <Manual tune> and press ENTER, use / button to
select station from 5A:174.928MHz to 13F:239.200MHz.
Then press ENTER button to activate the selected station.
FM Operation
Select stations
To search for an FM station from 87.5 to 108.0MHz.
1. Press and hold the / to skip to the previous or next station of
strongest reception. Once a station has been found, it stops
scanning automatically. If no station is found, the unit will stop
after it has cycled through the entire frequency.
2. Briefly press the / to reward or forward the frequency by the
step of 0.05MHz.
3. Long press the ENTER button to auto scan the 30 stations.
4. To locate the required station, long press PRESET, press / to
select required station from the scanned stations, then press
ENTER to confirm. To Store Stations, refer page 5, General
Operation.
Station tuning
Press and hold the INFO/MENU button to enter the <Audio
setting>, press ENTER, then press the / to select one of the
audio mode Stereo or mono or Mono only, at last press ENTER to
confirm.