Lenco PDR-03 - Manual (Page 7)

6
Follow the steps to manually update the time and date.
Press and hold the INFO/MENU button to find the <Main menu>
and press ENTER, press / and press ENTER to enter the <Time
setup>. Then press ENTER button to enter the selection interface.
Press / button to select the digits of the time and date.
1. Set clock> Press ENTER> 00:00(Hour:Minutes)> Press / to
select the Hour digits> Press ENTER> Press / to select the
Minute digits> Press ENTER to confirm.
2. Set date> Enter the date 01-01-2014 (Day-Month-Year)>
Use the above steps of SET CLOCK to select the digits of the
date, press ENTER to confirm.
3. Auto update> Select No update or From radio> Press ENTER
to confirm selection.
*If selected NO UPDATE, the time and date will not update from
the system, and you should manually set the time and date.
*If selected FROM RADIO, the time and date will auto update
from the system if it detects the RDS signal. But if the RDS
signal is not strong enough, the time/date will not update.
4. After finish the steps above, the time is set up manually.
Manual set Time
When the <Alarm 1: off> appears,
1. Press ENTER button to set the alarm ON, press / until the
screen display as:
Time: 00:00 , then press ENTER.
Use the / to select alarm digits, press ENTER to confirm.
2. Select the alarm days: Daily, Once, Weekdays, Weekends.
3. Set the alarm mode: DAB, FM, Buzzer.
*If you choose the DAB or FM mode as the alarm mode, when the
alarm goes on, the unit will turn on to the corresponding radio.
*If you choose the Buzzer mode, when the alarm goes on, there
comes a audible sound, press ENTER button to set the alarm to
the nap mode, and the alarm will goes on again 5 minutes later.
Press and hold the SLEEP button can stop the alarm.
4. Set the presets, this option enables the unit to turn on from the
preset station or the last listened station if unit is set to alarm in
FM or DAB mode with preset stations.
5. Set the alarm volume level, there is a slide bar for adjusting the
alarm volume, press / buttons to increase or decrease the
volume level, press ENTER to confirm.
6. After all the above steps, enter the SAVE interface, press ENTER
Set the Alarms