Lenco SCDi-01 - Manual (Page 10)

GB 8
If at any time in the future you should need to dispose of this product please note that: Waste electrical products
should not be disposed of with household waste. Please recycle where facilities exist. Check with your Local
Authority or retailer for recycling advice. (Waste Electrical and Electronic Equipment Directive)
Where to place the item :
Today’s furniture is coated with a wide variety of lacquers and synthetic-coatings that are treated with an extensive range
of cleaning products. Therefore, the possibility that some of these substances contain components that react adversely to
the rubber feet of the item and soften them, cannot be completely excluded. The rubber feet of the appliance can cause
discoloring to furniture surfaces. If necessary, place the appliance on a non-slide surface.
��E�IFI�ATION�
��� �E�TION
Channels: 2 channels
S / N ratio: 60 dB
Wow & Flutter: undetectable
Sampling frequency: 44.1 kHz 8 x over sampling
Quantization: 1 bit DA converter
Pick up light source: Semi - conductor laser
Pick up wave length 790 nm
�A��IO �E�TION
Tuning ranges : FM 87.5 - 108 MHz
AM 522 - 1620 kHz
Antennas : AM Built - in ferrite bar
FM telescopic antenna
GENE�AL
Output power: 2 W + 2 W (RMS)
Power consumption: 15 W
Speaker: 3" 8 OHM
Phones jack: 3.5 MM
AUX IN jack 3.5 MM
Power source: AC: 230V ~ 50Hz
DC: 12V 1.5 x 8 UM2 / LR14 / "C" SIZE
Clock back up Battery 1.5 x 3 AAA / LR03
Dimensions:
Main unit 438 (L) x 262 (D) x 143 (H) mm
Remote control : 35 (L) x 18 (D) x 190 (H) mm
Weight 2.7KGS
Due to continuing improvement, the features and the design are subject to change without notice.
WA�NING
Should the CD door be opened before the reading of the CD
is completed, a jamming noise may occur. This is resolved
by closing the CD door.
�LEANING THE UNIT
Do not use volatile chemicals
on this unit. Clean by lightly
wiping with a soft cloth.
IM�O�TANT NOTE
If an abnormal display indication or an operating problem
occurs, disconnect the AC power cord and remove the
batteries. Wait at least 5 seconds, then reconnect the AC
power cord or reinstall the batteries.
�LEANING ���
If the CD skips or will not play, the disc may need cleaning.
Before playing, wipe the disc from the centre out with a
cleaning cloth. After playing, store the disc in its case.
MAINTENAN�E
�LEANING THE ��� LEN�
If the CD lens is dusty, clean it with a brush-blower. Blow
several times on the lens and remove the dust with the
brush. Finger prints may be removed with a cotton swab
moistened with alcohol.
For information and support, www.lenco.eu
SCDI-01 LENCO ENGLISH IM NO RCA 10 10 15/6/2011 14:48:22